Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

flash is formatted on ROMMON, but can't be opened

Hi,

On ROMMON mode, I downloaded an ios image using tftp, it says:

Copying file c2800nm-ipbase-mz.124-9.T3.bin to flash:.

program load complete, entry point: 0x8000f000, size: 0xcb80

Format: All system sectors written. OK...

Format: Operation completed successfully.

Format of flash: complete

program load complete, entry point: 0x8000f000, size: 0xcb80

open(): Open Error = -13

create a file failed...err code = -1

Is it possible to salvage the flash card? Please advise.

Thanks!

Jon

  • LAN Switching and Routing
3 REPLIES
Silver

Re: flash is formatted on ROMMON, but can't be opened

Please paste your show tech?

New Member

Re: flash is formatted on ROMMON, but can't be opened

show tech output attached. thx.

New Member

Re: flash is formatted on ROMMON, but can't be opened

Any update to this case? I've got a similar problem, but with different Output Error of 14, not 13:

Format: All system sectors written. OK...

Format: Operation completed successfully.

Format of flash: complete

program load complete, entry point: 0x8000f000, size: 0xc5a0

Initializing ATA monitor library.......

open(): Open Error = -14

create a file failed...err code = -1

rommon 3 >

Got this after XMODEMing 12.4(1r) to 2811, after replacing the flash.

515
Views
0
Helpful
3
Replies
This widget could not be displayed.