I'm trying to determine the point of the flash keyword in the boot system command on a Sup-720. From what I can see I dont need to specify it but I would be interested to know if there is a good reason to specify it?
For example I can spectify:
boot system sup-bootdisk:IMAGENAME.bin
and everything works fine. However in the command reference it seems to indicate that I should put the following in:
boot system flash sup-bootdisk:IMAGENAME.bin
If anyone can clarify this then it would be appreciated.
What I was actually after was whether I need to specify the keyword "flash" in the boot system command? I know the switch boots correctly when flash isnt included in the boot system command but was wondering if there were any reasons to include the flash keyword?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...