Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Flexwan Module

I just install a flexwan module in 6513 switch, the 6513 is running native IOS. I sent the command to power up the module but the logs are say that the device is unsupported

1 REPLY
Purple

Re: Flexwan Module

You need to check to see if your version of code supports the flexwan you have installed ,sounds like a compatability issue with your code .

116
Views
0
Helpful
1
Replies
CreatePlease to create content