Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Flow control

I had 12416 router with Modular SPA Interface Card (10G) card

on one of its port it shows flow control off and on other it shows on. How can I make it off

---------------

CHD-ISP-COR-RTR-22#sh int gigabitEthernet 4/0/2

GigabitEthernet4/0/2 is up, line protocol is up

Hardware is GigabitEthernet, address is 0019.2f42.6202 (bia 0019.2f42.6202)

MTU 1500 bytes, BW 110592 Kbit, DLY 10 usec, rely 255/255, load 226/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full Duplex, 1000Mbps, link type is autonegotiation, media type is SX

output flow-control is off, input flow-control is off

CHD-ISP-COR-RTR-22#sh int gigabitEthernet 4/0/3

GigabitEthernet4/0/3 is down, line protocol is down

Hardware is GigabitEthernet, address is 0019.2f42.6203 (bia 0019.2f42.6203)

MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec, rely 255/255, load 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full Duplex, 1000Mbps, link type is autonegotiation, media type is SX

output flow-control is on, input flow-control is on

Pl. suggest

Mahesh

5 REPLIES

Re: Flow control

New Member

Re: Flow control

CHD-ISP-COR-RTR-22(config)#int gigabitEthernet 4/0/3

CHD-ISP-COR-RTR-22(config-if)#flo

CHD-ISP-COR-RTR-22(config-if)#flow ?

% Unrecognized command

this command is not working

Pl. suggest

Re: Flow control

I've just seen this is a 12000 so I may be out of my depth. Is it XR?

If it was my 4500, I would do show int G4/0/3 capabilities to check my options, and look for the flow control capabilities. It is always possible that it does not suppport static configuration and the only option is "desirable". If that is the case, then it depends entirely what is at the other end of the link.

Kevin Dorrell

Luxembourg

New Member

Re: Flow control

this comand is not working

Mahesh

Re: Flow control

I guess it is XR then, and I really cannot help you. Sorry.

209
Views
0
Helpful
5
Replies
CreatePlease to create content