Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

frame relay maps

Hi all, If I have a multipoint connection at site A, with a multipoint interface with various maps, on the spoke sites, can we just set it up on the serial interface and just use encap frame-relay, or do I have to map it ?

2 REPLIES
Bronze

Re: frame relay maps

Hi Carl,

On the spoke router you will NOT have to map the IP address/DLCI of the hub router. However, if you have other spoke sites on the same subnet which you need direct connectivity to then these will have to be mapped statically.

HTH

Mike.

Cisco TAC.

New Member

Re: frame relay maps

can someone show me an example config for this ?

109
Views
0
Helpful
2
Replies