Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame Relay on Dynamips

hi there, can someone please explain how to telnet into a FR Switch in Dynamips? telnet into routers is working ok but when you type telnet FRSW nothing happens. how do you configure the FRSW if you cant get into it?

Regards

3 REPLIES

Re: Frame Relay on Dynamips

The Frame Relay switch is configured DLCI-DLCI in your config file, but you dont actually have telnet access to it.

If you look at the state of the Frame switch you will see it is n/a instead of stopped or started.

http://www.dynagen.org/tutorial.htm

New Member

Re: Frame Relay on Dynamips

matt

many thanks for the reply and the link.

Silver

Re: Frame Relay on Dynamips

Hi Solpandor

Just to add my 2 cents worth if I may.

The generic frame switch in dynamips provides a full mesh frame relay topology and as has already been pointed out you can not access this frame switch.

However you could configure a normal router in dynamips as a frame switch the same way you would in a home lab and configure point to point or point to multipoint links and in this instance you would have access to the frame switch.

Here are two links I came across when I was running frame relay on dynamips myself

http://7200emu.hacki.at/viewtopic.php?t=3187

http://dynagen.cn/frame-relay-point-to-multipoint-lab/

HTH

Best Regards,

Michael

387
Views
0
Helpful
3
Replies