Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame Relay w/ OSPF

Hello Everyone,

Here I am again, asking question. Why is it that I can't ping R3 loopback interface? But on other routers PING works fine.

R1# show ip ospf neighbor

Neighbor ID               Pri                    State                         Dead Time                Address                Interface

N/A                           0           ATTEMPT/DROTHER                    -                      10.1.1.4              Serial 0/0.12

2.2.2.2                       1          FULL/DR                              00:01:52                   10.1.1.3              Serial 0/0.12

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Frame Relay w/ OSPF

I think your R1's config is not good. You have two FR subifs in the same IP subnet...

interface Serial0/0.12 multipoint

ip address 10.1.1.1 255.255.255.248

frame-relay map ip 10.1.1.3 102 broadcast

!

interface Serial0/0.13 multipoint

ip address 10.1.1.2 255.255.255.248

frame-relay map ip 10.1.1.4 103 broadcast

1 REPLY
Bronze

Frame Relay w/ OSPF

I think your R1's config is not good. You have two FR subifs in the same IP subnet...

interface Serial0/0.12 multipoint

ip address 10.1.1.1 255.255.255.248

frame-relay map ip 10.1.1.3 102 broadcast

!

interface Serial0/0.13 multipoint

ip address 10.1.1.2 255.255.255.248

frame-relay map ip 10.1.1.4 103 broadcast

263
Views
0
Helpful
1
Replies
CreatePlease login to create content