Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

frame relay

Hi every body!

I have few questions about frame relay.

1) When a client orders a frame relay service, what information/configurations are provided by telco besides dlci?

2)The lapf header and trailer does not have protocol type feild. Cisco and three other companies created an additional header which comes between the lapf header and layer 3 packet. It includes a 2 byte protocol type feild.

What were the those three companies? Does it mean the routers from these companies can work together using " cisco encapsulation" since these companies together created this header to make up for the absence of protocol type field in lapf header and trailer?

Thanks a lot!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: frame relay

Hello Sarah,

1) a FR PVC is defined by the DLCI and by the traffic parameters that can apply to it: CIR, burst rate, MBR and so on

These are contracted but can be used to implement effective FR traffic shaping

2)

This is a too old story since 1992 a standards based protocol type optional field has been added to FR.

So FR IETF encapsulation allows for multiprotocol too.

see

http://www.rfc-editor.org/rfc/rfc1294.txt

and later RFC 2427

the real difference is in HDLC where Cisco HDLC has a protocol type and standard HDLC hasn't at all.

Hope to help

Giuseppe

1 REPLY
Hall of Fame Super Silver

Re: frame relay

Hello Sarah,

1) a FR PVC is defined by the DLCI and by the traffic parameters that can apply to it: CIR, burst rate, MBR and so on

These are contracted but can be used to implement effective FR traffic shaping

2)

This is a too old story since 1992 a standards based protocol type optional field has been added to FR.

So FR IETF encapsulation allows for multiprotocol too.

see

http://www.rfc-editor.org/rfc/rfc1294.txt

and later RFC 2427

the real difference is in HDLC where Cisco HDLC has a protocol type and standard HDLC hasn't at all.

Hope to help

Giuseppe

100
Views
0
Helpful
1
Replies