Hi all, I was looking at my book yesterday on frame relay, is it right that if you congigure it on a serial interface ie s0, you only need to put the encapsulation in if it supports inarp? can we do this if we have multiple dlci's or would we have to use the frame interface dlci command on each instance of a sub interface ?
For your first question, inverse arp only works on routers that have a direct PVC between them . For those who don't have direct PVC (like spoke routers in a hub-n-spoke topology), you will need to configure a static frame-relay map. For example, R1 has one PVC connected to R2 and another PVC connected to R3, but R2 and R3 have no PVC to directly connect them. To establish ip connectivity between them, the following commands is needed:
frame-relay map ip R3-ip-address R2-dlci
frame-relay map ip R2-ip-address R3-dlci
The other way to configure full ip connectivity is use the point-to-point sub-interfaces. Configure ip address on each sub-interface and assign the correct dlci to it. Then you should have ip connectivity to the router on the other end of this PVC. Notice that each subinterface is on different sunet from others, so you will need to enable routing protocol (or use static route) to make full ip connectivity between them. A sample configuration is like below:
int s0.1 point-to-point
ip address 10.1.1.1 255.255.255.252
frame-relay interface-dlci 102
int s0.2 point-to-point
ip address 10.1.1.5 255.255.255.252
frame-relay interface-dlci 103
Or, you can have mixed configuration of this two kind. Some subinterfaces is point-to-point and the others use point-to-multipoint. The configuration of point-to-multipoint subinterfaces is the same as that of physical interfac except that it is on the sub-interface.A sample configuration is like below:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...