I have a router (1841) with 5 class of QoS. I have too a map-class when i configured cir=512000, mincir=512000, bc=5120, be=0 and fragment=640, all my class traffic data, but the Voice class no. But when i configured no cir, mincir=256000, bc=2560, be=0 and fragment=320, all class traffic data and the Voice class too. What's problem? The link of ISP is 512000
You should match the cir/mincir values with that of the Telco switch. For voice traffic, the quality will be better if there is burstiness is kept to a minimum. So we recommend keeping cir == mincir. Also, we recommend keeping the packetisation interval at 10ms. You have accomplished this by setting the bc to cir/100.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...