Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FTP from VLAN1 to VLAN2 on a 3750 catalyst not possible

hi,

on a 3750 catalyst ( Version 12.2(25)SEE2 )

it's not possible to start a FTP from a client in VLAN1 to a server in VLAN2;

is the same client also in VLAN2 than it works fine...

there is no firewall/access list defined...

i get:

ftp> open xxx.xx.xx.xx

connected to xxx.xx.xx.xxx.

connection closed by Remotehost.

ftp>

a telnet and ping xxx.xx.xx.xxx is possible!

any help/idea?

thanks,

martin.

5 REPLIES
Anonymous
N/A

Re: FTP from VLAN1 to VLAN2 on a 3750 catalyst not possible

What are you using to route between the VLANs? Are you using the 3750 or an external router?

Re: FTP from VLAN1 to VLAN2 on a 3750 catalyst not possible

Martin,

Do you have the command "ip routing" in your config?

Brandon

New Member

Re: FTP from VLAN1 to VLAN2 on a 3750 catalyst not possible

So, if u could ping/telnet it between vlan's, routing is fine.

Is there any acl filtering ftp traffic ?

Best Regards,

Bruno Petrónio

New Member

Re: FTP from VLAN1 to VLAN2 on a 3750 catalyst not possible

1) the routing is done by the switch itself

2) no i have no "access list"

3) yes, i have the parameter ip routing

here the starting from the config:

....

....

switch 1 provision ws-c3750g-48ts

switch 2 provision ws-c3750g-48ts

switch 3 provision ws-c3750-48ts

ip subnet-zero

ip routing

no ip domain-lookup

!

!

!

!

no file verify auto

!

spanning-tree mode pvst

spanning-tree extend system-id

spanning-tree vlan 1,10-14 priority 24576

!

vlan internal allocation policy ascending

!

interface Port-channel1

switchport mode access

spanning-tree portfast

spanning-tree bpdufilter enable

!

interface Port-channel2

switchport trunk encapsulation dot1q

switchport mode trunk

shutdown

!

interface GigabitEthernet1/0/1

description S1svaEN1

switchport mode access

speed 1000

duplex full

spanning-tree portfast

....

....

thx,

martin

Silver

Re: FTP from VLAN1 to VLAN2 on a 3750 catalyst not possible

Hi Martin

Are you sure that the problem is with the 3750?

From the FTP information supplied,

ftp> open xxx.xx.xx.xx

connected to xxx.xx.xx.xxx.

connection closed by Remotehost.

ftp>

it appears that you have been connected to the server and that something on the server has then ended the session.

If there was a routing problem on the 3750 I would have expected something like the following,

H:\>ftp

ftp> open 10.10.10.1

> ftp: connect :Connection timed out

ftp>

If the server is a windows based server, is it possible that there is a local firewall (windows firewall) terminating your FTP session?

Best Regards,

Michael

249
Views
0
Helpful
5
Replies