Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Full Duplex

Hi I have 2 cisco 2950 switches connected/linked together by 2 EtherMux Microwaves 100Mbyte Link, one on each site. These Ethermux Microwave devices only support 100 Full duplex. Before I turn on the 100 full duplex on the switches, the link is very reliable. After I had turned it on (speed 100, full duplex), the link are very unstable, sometime it will drop packet and result in connectivity lost

3 REPLIES

Re: Full Duplex

HI,

Can you pls check with the vendor of the MUX regarding the Speed / Mode of the MUX interface.

I hope Auto Mode will work perfectly for this issue. Can you pls check & answer

Pls Rate if helps

Best Regards,

Guru Prasad R

New Member

Re: Full Duplex

I had checked with the vendor, they said the MUX only support 100Mbyte Full Duplex

Re: Full Duplex

Hi,

As a concept you must have either both sides Auto negotiation, or you'll have to manually config both sides with 100/Full. (according to your symptoms the MUX supports Auto, and when you manually set on the switch to 100/Full your MUX defaults to Half duplex which is your problem).

Another thing you might need to check here is your cables.

HTH, please do rate all helpful replies,

Mohammed Mahmoud.

108
Views
0
Helpful
3
Replies