Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM hostname on redundant unit

After configuring failover on FWSM, the hostname on the secondary unit gets overwritten. Can this be avoided. I would like to identify via the hostname that which one is active.

Regards.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: FWSM hostname on redundant unit

The code you are running A1(6.3a) doesnt support this command.

Syed Iftekhar Ahmed

3 REPLIES

Re: FWSM hostname on redundant unit

Use Prompt command on primary to recongnize which one is active.

prompt hostname context state

Will add sate (primary/secondary) to the prompt.

Your prompt will show you if you are working on an Active or Standby FWSM

HTH

Syed Iftekhar Ahmed

New Member

Re: FWSM hostname on redundant unit

Re: FWSM hostname on redundant unit

The code you are running A1(6.3a) doesnt support this command.

Syed Iftekhar Ahmed

257
Views
5
Helpful
3
Replies