Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM VLANs do not show up

Configuring FWSM in a 6509.  When I set "firewall vlan-group 40  40-42,251", it results in: "No more than one svi is allowed. Command rejected.". 

I had "firewall multiple-vlan-interfaces" set for a previous use of this module, but took that off with the "no" command. 

Suspect that is the issue, but do not see how to resolve.  Seems similar to bug CSCsr48563, but I am at the fixed code for that bug.

Everyone's tags (3)
1 REPLY

FWSM VLANs do not show up

Hi,

its been 4 years since i saw this message when implementing the fwsm. so i m not sure, but if i remember right its an "issue the commands in the right order"  issue.

Delete all fw statements from the 6500 config

Delete the interface which routes to the fwsm from the 6500

Enter the commands again starting with

firewall multiple-vlan-interfaces

firewall module x vlan-group 1

firewall vlan-group 1 2

interface Vlan 2

ip ....

etc.

Hope it helps, its long ago.

648
Views
0
Helpful
1
Replies
CreatePlease login to create content