Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

FWSM

hi,

what is command to check the image in fwsm?

Regards

Rajeev

7 REPLIES

Re: FWSM

Hi Rajeev

I think you can confirm it in "show module" on MSFC. or "show version" on FWSM.

HTH

Tomoyuki

New Member

Re: FWSM

Thanks for our reply

But it does not show the complete file and its size. If i have to verify is the downloded size is correct, how can i do it

Re: FWSM

I would like to suggest you login to FWSM by "session slot processor 1".

And may well be able to confirm in something like "show flash" on the FWSM.

HTH

Tomoyuki

New Member

Re: FWSM

Hi I am tring to upgrade the FWSM image but while pinging to switch i am getting packet drops...What may be the reason.

just attached logs of FWSM.

FWSM# ping 172.23.88.250

Sending 5, 100-byte ICMP Echos to 172.23.88.250, timeout is 2 seconds:

??!?!

Success rate is 40 percent (2/5), round-trip min/avg/max = 1/1/1 ms

FWSM# ping 172.23.88.250

Sending 5, 100-byte ICMP Echos to 172.23.88.250, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

FWSM# ping 172.23.88.250

Sending 5, 100-byte ICMP Echos to 172.23.88.250, timeout is 2 seconds:

!!?!!

Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/1 ms

FWSM# ping 172.23.88.250

Sending 5, 100-byte ICMP Echos to 172.23.88.250, timeout is 2 seconds:

????!

Success rate is 20 percent (1/5), round-trip min/avg/max = 1/1/1 ms

FWSM#

New Member

Re: FWSM

Hello,

That may be due to physical errors.

You can ping the same address from the Switch directelly ?

Regards,

Omar

New Member

Re: FWSM

nop here also i was getting error..

I was able to ping switch, fw also but with packet drop. i also tried from switch and same response

New Member

Re: FWSM

Hello,

If you arrive to ping the FWSM that means that it's running the OS and getting the IP.

Can you please send the output of the command #show tech-support of the CAT 6500 ?

Regards,

Omar

255
Views
3
Helpful
7
Replies
CreatePlease to create content