The gateway is the Router / PC(server) like one company have 50 nodes LAN with 2 L2 switches and 2 Routers for redundant purpose, in other location also same thing. Now which we can configure as a Gateway and what r the steps shall I take.
Sicne you have only L2 Switches. Use the IP Address of the Router Interface connecting to the Switch as Gateway address of all Clients in HO
HO - BO:
You can configure the end - to - end communication between these two offices with some Routing Protocols / Floating Static Routes since you use the Redundancy. You can use Ethernet Comm... / Serial Port Comm...based on your Service Provider, Cost, etc.,
INFO:If you are going to have VLAN Setup in your environment then VLAN Router IP will be the Gateway IP Address of the Clients. (Since you have only L2 Switches this may not be required for you neverthless as Tech Info).
For redundancy you can use Floating Static Routes. Primary Static Route as default to Primary link and Secondary (redundancy) static route to Backup Link with AD as 200.
Else, you would like to use only protocols for redundancy then EIGRP, OSPF, etc., Refer link below for study documents:
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...