I am connecting 3560E switches to a 4507R core switch. Existing fiber connects the IDF locations for the 3560s to the MDF location for the core switch. The multimode fiber plant takes ST connectors. The GBICs - GLC-SX-MM and WS-G5484 - require LC connectors. Beyond simply ordering LC to ST patch cables in the right length, I have been told that I should specify short wave versus longwave fiber for the patch cables. Is there anything to that?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...