Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Gbic port unusable

error massage:

POST: Inline Power Controller Tests : Begin

POST: Found inline power controller write failure, inst 0

POST: Inline Power Controller Tests : End, Status Failed

Gbic port not functions.

why this happen coz of hardware or software?

3 REPLIES

Re: Gbic port unusable

Too bad; POST-failures are mostly hardware.

Leo

New Member

Re: Gbic port unusable

Hi,

I've got the same issue. To be more specific I found that i went into this issue only when, in a 3560-24P, i insert both sfp.

If i insert only one of them all is working fine

Had You any news ?

regards

Luigi

Hall of Fame Super Gold

Re: Gbic port unusable

In enable mode, try the command "show post". The results should be "End, Status Passed". If the result comes back as "failed" then you need to RMA the switch.

174
Views
0
Helpful
3
Replies