I have question for you all with respect to GBIC-SX cards , these cards currently connected to switch WS-C2950G-48-EI
planning to upgrade switch to WS-C2960S-48LPS-L with GLC-SX-MMD , however customer like to use same cable which are connected to old switch GBIX_SX card to new switch GLC-SX-MMD cards , would like to know is this works
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...