Hi I'm am playing around with home automation and are getting annoyed with battery powered motion sensors the tie into my fibaro zwave network.
I run run a full Cisco home with 3850p and 3560 p and I want to start to use there some what 48 spare ports I have to do other things with. But what I want to know is there some device I can get to get access to all this D.C. Power that can then step down the the required voltage. Or someway to at least get access to the raw 48v and then use aftermarket converters.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...