Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

get TRUNK Cisco 881 and HP2510


I got some problem getting the trunk up and running as my HP knowledge is limited I’m looking for some expert advice hence the reason I ask it here.

1) is it possible with Cisco 881 

2) if possible what the best config at the HP, assuming the cisco is correct please below some excerpt of the config

3) I’ve no admin control on the HP 2510

4) Below are some links about trunk set up between Cisco/HP maybe we misread something

Cisco 881

IOS flash:c880data-universalk9-mz.151-4.M6.bin

HP 2510

ProCurve-2510G-24-SRVRM release #Y.11.12

Problem: getting the Trunk between Cisco 881 and HP2510

Cisco 881 Trunk config

interface FastEthernet3

switchport trunk allowed vlan 1-4,1002-1005

switchport mode trunk

no ip address

spanning-tree portfast

HP 2510 config ( partly)

vlan 3

   name “OFFICE” LAN

   untagged 4,22

   no ip address

   tagged 5-6,14,Trk1-Trk2


vlan 4

   name “WIFI

   tagged 11-12,14-15,Trk1-Trk2


trunk 7-8 Trk1 LACP

trunk 9-10 Trk2 LACP

spanning-tree Trk1 priority 4

spanning-tree Trk2 priority 4

Note: I am aware that LACP is not possible with Cisco 881.

it looks like  the HP2510 con only handle only one LACP or 802.1q,  if that's the case we another challenge   

VLAN Trunk Between Cisco and HP Procurve switch

Cisco and HP Procurve Trunk 802.1Q

Trunk between HP switch and Cisco switch

Trunking between a Cisco switch and an HP Procurve

CreatePlease to create content