Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

getting gig interface down

GigabitEthernet0/3 is up, line protocol is down is error i ma getting what hsould i check and how to rectify it

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: getting gig interface down

Amit

Interface up line protocol down sometimes means that there is not anything plugged into the interface.

I believe that it can also result from a speed mismatch. So check the switch interface and verify speed and duplex settings. Then verify on the device connected to the port what its speed and duplex settings are. Make sure that speed and duplex settings are the same.

HTH

Rick

2 REPLIES
Hall of Fame Super Silver

Re: getting gig interface down

Amit

Interface up line protocol down sometimes means that there is not anything plugged into the interface.

I believe that it can also result from a speed mismatch. So check the switch interface and verify speed and duplex settings. Then verify on the device connected to the port what its speed and duplex settings are. Make sure that speed and duplex settings are the same.

HTH

Rick

Hall of Fame Super Silver

Re: getting gig interface down

Amit

I am glad that my answer was helpful. Thank you for using the rating system to indicate that your issue was resolved (and thanks for the rating). It makes the forum more useful when people can read about an issue and can know that they will read about the successful resolution of the issue.

The forum is an excellent place to learn more about Cisco networking. I encourage you to continue your participation in the forum.

HTH

Rick

191
Views
5
Helpful
2
Replies