I am trying to set-up GLBP on new 6506-E chassis we recently received with Sup720-10G-VSS supervisor blades. The IOS is a modular IOS which does support GLBP going by the feature navigator, but when you create a interface there is no commands for GLBP.
I have noticed the following command at the foot of the sh ver -
Patching is not available since the system is not running from an installed image. To install please use the "install file" command
But l am not sure if this is something that has not been installed on the chassis? As l carry out a show install running, l get the following -
System is currently not running from installed software?
Has anyone configured GLBP on teh 720-VSS or came across a similar issue.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...