Well, I can't answer why they haven't added it yet, but they have been adding support very gradually. At first it was only on 7200s, then they added 6500s. I guess maybe in a few years we mat get it on more hardware.
I have two 3825 routers which seemed to run glbp fine, however, I could not communicate to the 3750 switch behind the routers after implementing glbp. HSRP seems to work just fine. Is that what you meant by glbp is not supported on the 3750? If not, does anyone have an idea why implementing glbp on the routers would break connectivity to the switch?
The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.
In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.
That's the type of question that only Cisco can answer. It could be, the 3750 architecture is an impediment; it could be with 3750 stacking, who needs it; it could be with a L3 switch Cisco doesn't see the need to load balance hosts; it could be . . .
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...