I have configured GLBP in my both router using round robin method. And I do the monitoring on my link. There is a lot difference usage of the both link, so i assume GLBP is not the packet switching balancing. Do GLBP support for packet switching balancing? How to configure that?
You are correct that round robin is not doing packet switching balancing. With round robin each Virtual Forwarder MAC address is used sequentially in ARP replies for the virtual IP address. So, if the first device that ARPs sends a lot more traffic than the second device that APRs, you will see more traffic on the one link. You cannot do packet switching load balancing using GLBP. You can do weighted or host dependent to make your traffic flows more even. See this link:
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...