VoIP deployment 100 phones, PC's, two ISR's and a switch. I would like to setup a DHCP server for the phones on the ISR and have a DHCP helper for the PC's. I wanted to setup an environment where there is a level of redunancy for the DHCP pools on the ISR's.
How does the DHCP server portion work on the router in the event of a failure? Is it wise to setup identical or split up DHCP pools on both ISR's?
are you using HSRP ? then one of the routers is the active an one is the standby for the ip interfaces. so if you configure isr1 witch x.x.x.2 and isr2 with x.x.x.3 an the virtuel interface with x.x.x.1..... the ip helper will be the virtuell interface... the primary router will answer.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...