07-21-2013 08:24 AM - edited 03-07-2019 02:30 PM
hello all,
I have successfully configured GLBP on my network but i have some doubts. how can i verify that traffic is actually being balanced on both outbound links? another thing is...i have one 60meg link and one 15meg link, how can i make more traffic go out the link with 60meg?
07-21-2013 08:37 AM
Hi,
If you want traffic to go out the 60mb link, then you raise the priority of AVG on the router that connects to your 60mb link.
Here is good doc to refer to on how to do it:
http://blog.ine.com/2008/04/24/glbp-explained/
HTH
07-21-2013 11:12 AM
Hi Reza,
thanks for the link. it is very helpful. I think there is a twist to my config. I have BGP running on both routers as well and i have set some local pref on the routers, meaning, even if i am GLBP'ing i am not actually using one link right? isn't that what the local pref config does? check out below;
#sh glbp
GigabitEthernet0/1 - Group 1
State is Active
1 state change, last state change 02:27:31
Virtual IP address is 192.168.1.1
Hello time 3 sec, hold time 10 sec
Next hello sent in 2.692 secs
Redirect time 600 sec, forwarder time-out 14400 sec
Preemption enabled, min delay 0 sec
Active is local
Standby is 192.168.1.3, priority 100 (expires in 7.636 sec)
Priority 150 (configured)
Weighting 100 (default 100), thresholds: lower 1, upper 100
Load balancing: round-robin
Group members:
0023.5e29.9401 (192.168.1.2) local
5057.a856.c281 (192.168.1.3)
There are 2 forwarders (1 active)
Forwarder 1
State is Active
1 state change, last state change 02:26:56
MAC address is 0007.b400.0101 (default)
Owner ID is 0023.5e29.9401
Redirection enabled
Preemption enabled, min delay 30 sec
Active is local, weighting 100
Forwarder 2
State is Listen
MAC address is 0007.b400.0102 (learnt)
Owner ID is 5057.a856.c281
Redirection enabled, 597.680 sec remaining (maximum 600 sec)
Time to live: 14397.508 sec (maximum 14400 sec)
Preemption enabled, min delay 30 sec
Active is 192.168.1.2 (primary), weighting 100 (expires in 9.888 sec)
R1
router bgp 100
no synchronization
bgp router-id 44.20.14.2
bgp default local-preference 200
R2
router bgp 100
bgp log-neighbor-changes
bgp default local-preference 150
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: