Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

GLBP traffic

hello all,

I have successfully configured GLBP on my network but i have some doubts. how can i verify that traffic is actually being balanced on both outbound links? another thing is...i have one 60meg link and one 15meg link, how can i make more traffic go out the link with 60meg?

Everyone's tags (1)
2 REPLIES
VIP Super Bronze

GLBP traffic

Hi,

If you want traffic to go out the 60mb link, then you raise the priority of AVG on the router that connects to your 60mb link.

Here is good doc to refer to on how to do it:

http://blog.ine.com/2008/04/24/glbp-explained/

HTH

New Member

GLBP traffic

Hi Reza,

thanks for the link. it is very helpful. I think there is a twist to my config. I have BGP running on both routers as well and i have set some local pref on the routers, meaning, even if i am GLBP'ing i am not actually using one link right? isn't that what the local pref config does? check out below;

#sh glbp

GigabitEthernet0/1 - Group 1

  State is Active

    1 state change, last state change 02:27:31

  Virtual IP address is 192.168.1.1

  Hello time 3 sec, hold time 10 sec

    Next hello sent in 2.692 secs

  Redirect time 600 sec, forwarder time-out 14400 sec

  Preemption enabled, min delay 0 sec

  Active is local

  Standby is 192.168.1.3, priority 100 (expires in 7.636 sec)

  Priority 150 (configured)

  Weighting 100 (default 100), thresholds: lower 1, upper 100

  Load balancing: round-robin

  Group members:

    0023.5e29.9401 (192.168.1.2) local

    5057.a856.c281 (192.168.1.3)

  There are 2 forwarders (1 active)

  Forwarder 1

    State is Active

      1 state change, last state change 02:26:56

    MAC address is 0007.b400.0101 (default)

    Owner ID is 0023.5e29.9401

    Redirection enabled

    Preemption enabled, min delay 30 sec

    Active is local, weighting 100

  Forwarder 2

    State is Listen

    MAC address is 0007.b400.0102 (learnt)

    Owner ID is 5057.a856.c281

    Redirection enabled, 597.680 sec remaining (maximum 600 sec)

    Time to live: 14397.508 sec (maximum 14400 sec)

    Preemption enabled, min delay 30 sec

    Active is 192.168.1.2 (primary), weighting 100 (expires in 9.888 sec)

R1

router bgp 100

no synchronization

bgp router-id 44.20.14.2

bgp default local-preference 200

R2

router bgp 100

bgp log-neighbor-changes

bgp default local-preference 150

189
Views
0
Helpful
2
Replies
CreatePlease login to create content