GLC-T support on SM-2GE-SFP-CU

[buro_1986]

Hi,

I have been going through this Link http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6981.html

for check the compatibility information for gigabit Transrecievers but i am not able to find any information regarding gigabit transreciever compatibility with SM-2GE-SFP-CU. As i go through the datasheets of SM-2GE-SFP-CU it is mentioned:-

More information on features and a list of supported SFPs is found in the EHWIC-1GE-SFP-CU Data sheet

https://www.cisco.com/en/US/prod/collateral/routers/ps10536/data_sheet_c78-660124.html

Shall i assume the transreciever supported by EHWIC-1GE-SFP-CU will also be supported by SM-2GE-SFP-CU .

Thanks & Regards

Gautam Chakraborty

[acampbell]

Hi,

The left hand port in each side of the  SM-2GE-SFP-CU is Copper, the rught hand side are optical SFPs

So why would you want to fit a GLC-T.

Also you can only connect one port from each pair. IE it is 2 port card (NOT 4) so only coper or fibre in each pair.

Regards,
Alex.
Please rate useful posts.

[buro_1986]

Hi Alex,

Thanks for your update.

Actually i had a doubt whether this card have combo ports or only SFP Ports. As per datasheet of SM-2GE-SFP-CU it is  not clearly mentioned about dual purpose ports as compared to EHWIC-1GE-SFP-CU where it is very much clear. Thanks for your update i can save some cost for my customer.

Regards

Gautam Chakraborty

[acampbell]

Gautam,

Figure 1. Cisco SM-2GE-SFP-CU Service Module

Features

Look at the image , 2 ports for each interface,

The left hand ports are 1G Copper

The right hand ports are for Fibre SFPs

You use one or the other not both

Regards,
Alex.
Please rate useful posts.