07-06-2007 10:39 AM - edited 03-05-2019 05:10 PM
Have purchased a new ISR 2811. The 'Cisco Regulatory Compliance and Safety Information' pamphlet states that the ISR should be grounded during operation.
WOuld I be taking a risk if I configured the ISR 2811 without the ground in place? I do not have the ISR connected to my WAN or LAN and will not while configuring the device.
Any thoughts on my doing the config without a ground in place?
Thank you,
mgconghaile
07-06-2007 12:59 PM
mgconghaile
Perhaps I am not understanding something about your post but whether or not you have your WAN or LAN connected does not seem to have any impact on whether your router has a ground or not. In my experience many people install and operate routers like the 2800 series without installing the earth ground that is described.
HTH
Rick
07-06-2007 09:35 PM
mgconghaile
Mostly the rack you use to mount your devices would by itslef be grounded and in this case a seperate grouding would not be necessary for the device.
HTH
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: