Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

help 14339 input errors, 14339 CRC,

Hello

I have issues with swith remote, I am experiencing with 14339 input errors, 14339 CRC, is there a way of resolve this ?

This is my scenario Switch3550(fa 0/23)> Bridge> (fa 0/12) switch 2950

Anyone know of a workaround?

Please see attachment.

4 REPLIES

Re: help 14339 input errors, 14339 CRC,

CRC errors mostly point out to physical layer issues.

Check the cables and replace if necessary

Try different speed and duplex settings on the port and check for errors.

clear the counters and check if these errors are still increasing

HTH

Narayan

New Member

Re: help 14339 input errors, 14339 CRC,

Yes, I agree. Most of the time, CRC's point to physical layer problems.

Is your bridge managed? Do you have any info from that?

What are your port/duplex settings on both sides?

Thanks

Purple

Re: help 14339 input errors, 14339 CRC,

Those errors could almost be anything , first the counters have never been cleared since the box was last rebooted whenever that was . There may not even be a problem at this point.

Silver

Re: help 14339 input errors, 14339 CRC,

1. Issue "clear counters" command on both ends.

2. If errors add up, try "speed auto" and "duplex auto" on all ports

3. If errors add up, try "speed 100" and "duplex full" on all ports

4. If errors add up, try "speed 100" and "duplex half" on all ports.

Clear counters after each try and observe results.

117
Views
0
Helpful
4
Replies