Hi,
I am a networking student and was playing around with a Cisco 2800 series router. Couldnt figure out the pwd or user name so was following these steps from this KB
http://www.cisco.com/en/US/products/hw/routers/ps259/products_password_recovery09186a0080094675.shtml#ex_pass
for PWD and User Reset..... Although by the time I got to selecting a username and pwd the computer had went to sleep so I started over again.
When I restarting this process I ejected the Flash memory told it to reset but failed to reinsert the flash card before it rebooting....
now in the terminal I get symbols instead of words. What can I do ?
Thanks for taking the time to read this - Will
attached is a photo of the issue