Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Help Catalyast 2960G IOS deleted!!!

Ok, I have this 2960G switch that is used for practice. but one of my fellow class mates deleted the whole configuration in the switch, is their any way to put it in to ROMmon mode to get the IOS back on the switch? any help would be deeply appreciated.

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Help Catalyast 2960G IOS deleted!!!

Ok, I have this 2960G switch that is used for practice. but one of my
fellow class mates deleted the whole configuration in the switch, is
their any way to put it in to ROMmon mode to get the IOS back on the
switch? any help would be deeply appreciated.

Hi,

Check out the below link hope that help

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

If helpful do rate the post

Ganesh.H

2 REPLIES

Re: Help Catalyast 2960G IOS deleted!!!

Ok, I have this 2960G switch that is used for practice. but one of my
fellow class mates deleted the whole configuration in the switch, is
their any way to put it in to ROMmon mode to get the IOS back on the
switch? any help would be deeply appreciated.

Hi,

Check out the below link hope that help

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

If helpful do rate the post

Ganesh.H

New Member

Re: Help Catalyast 2960G IOS deleted!!!

Thanks it worked PERFECTLY!!!

1527
Views
0
Helpful
2
Replies
CreatePlease to create content