Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Help Changing 5510 ASA Interface IP

Dear All,

I am needing to change the internal IP scope for my network, however, when I make the change in my DCHP server I cannot change the Interface IP for my ASA 5510. Any ideas?

I have tried editing the Inside Interface Ethernet 0/1 AFTER the DHCP scope change and I lose communication along with several other errors. I have tried to edit the Inside Interface Ethernet 0/1 BEFORE the DHCP scope change and the same problems occur.

I have also tried disabling the Interface before making the change, however that didn't work either. I am guessing that there is a different area / way to change the IP for the Inside Interface Ethernet 0/1 than what I am doing.... any help would be greatly appreciated.

Thank you in advance!

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Help Changing 5510 ASA Interface IP

Hello,

I am assuming that you are using ASDM to access the firewall and making

changes in the ASDM. Please follow the steps below:

1> Through the ASDM, delete the DHCP scope on the firewall

2> Add the new IP range to the allowed addresses that can access ASDM

through HTTP (http 0 0 inside is a better option)

3> Now change the IP address on the inside interface

4> Configure a PC statically so that it has an IP in the same range as the

ASA's inside IP

5> Now access the ASA through the new IP from the statically configured PC

6> Now reconfigure the DHCP scope

Hope this helps.

Regards,

NT

3 REPLIES
Cisco Employee

Re: Help Changing 5510 ASA Interface IP

Hello,

I am assuming that you are using ASDM to access the firewall and making

changes in the ASDM. Please follow the steps below:

1> Through the ASDM, delete the DHCP scope on the firewall

2> Add the new IP range to the allowed addresses that can access ASDM

through HTTP (http 0 0 inside is a better option)

3> Now change the IP address on the inside interface

4> Configure a PC statically so that it has an IP in the same range as the

ASA's inside IP

5> Now access the ASA through the new IP from the statically configured PC

6> Now reconfigure the DHCP scope

Hope this helps.

Regards,

NT

Re: Help Changing 5510 ASA Interface IP

Hi,

Try to delete the interface and configure the interface once again in th below steps:-

ASA5510(config)# interface Vlan 1
ASA5510(config-if)# nameif inside
ASA5510(config-if)# security-level 100
ASA5510(config-if)# ip address 192.168.1.1 255.255.255.0
ASA5510(config-if)# no shut

Hope to Help !!

Ganesh.H

New Member

Re: Help Changing 5510 ASA Interface IP

NT,

Thanks. That helped. I had to make a couple of other minor adjustments but that worked out great.

Mat

1138
Views
0
Helpful
3
Replies
CreatePlease to create content