Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

help configure VLAN with Cisco 2950

I have Cisco Catalyst 4510R with two VLAN. Vlan1 and VLan2. I have a remote site that have a cisco 2950 switch. The remote site is connected to us directly. I want to be able to configure three ports on the remote site switch to be on and communicate with Vlan2 on the cisco 4510R.

Thank you

2 REPLIES
New Member

Re: help configure VLAN with Cisco 2950

The 2950 is a layer 2 switch I believe so you need to make sure you have a trunk to that switch from the 4510.

Then on the 2950 configure the port like this:

int "port"

switchport mode access

switchport access vlan 2

New Member

Re: help configure VLAN with Cisco 2950

I am new to this so is there a way for me to find if there is a trunk to switch 4510R. The remote site is connect through a T1 internet line and traffice goes through Pix 515e.

Thanks

364
Views
0
Helpful
2
Replies