Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

help! DHCP in 6509 can't work well

Hello,everyone!

I have two catlyst 6509(IOS Version 12.2(17a)SX4).And have about 30 vlan.And every vlan have a dhcp pool. cat6509-1 is the dhcp server for each vlan.And two 6509 run HSRP,cat6509-1 is the master .

long long ago, several PCs in vlan16(IP:10.0.15.0/24 , GW:10.0.15.254 in cat6509-1,the real ip is 10.0.15.252 , in cat6509-2 the real ip is 10.0.15.253) sometimes can't obtain IP address,To resolve this we may restart pc or config the static IP address for them.

But yesterday I config  the command in cat6509-1:

(config)#ip dhcp snooping vlan 16

then all PCs in that vlan can't access server (in vlan1 :131.107.0.0/24).And restart several PCs can't obtain IP address from cat6509-1. Then I config the static IP for one of the pc in vlan16 ,and ping 10.0.15.254 timeout  ,ping 10.0.15.252 timeout , ping 10.0.15.253 successful.

To resolve this problem,I cancel this command in cat6509-1:

(config)#no ip dhcp snooping vlan 16

but this can't resolve the problem.

finally , I shutdown interface vlan16 in cat6509-1,and setup a dhcp pool in cat6509-2 ,then cat6509-2 is the master in vlan16 HSRP ,and config a static route in cat6509-1:

(config)#ip route 10.0.15.0 255.255.255.0 10.0.0.2(the manage ip of cat6509-2)

the PCs in vlan16 work well.

but this is the temporary method . I want resolve this problem.

do you know the reason of the problem? And how i resolve it,and reture to normal status?

during this time I find some detail,this maybe helpful.

cat6509-1>show log

Jun 23 19:58:32 CTT: dhcp_snooping_draco2_new_dhcp_pak: failed to setup enqueue,

dropping DHCP packet!

Jun 23 19:58:36 CTT: dhcp_snooping_draco2_new_dhcp_pak: failed to setup enqueue,

dropping DHCP packet!

Jun 23 19:58:42 CTT: dhcp_snooping_draco2_new_dhcp_pak: failed to setup enqueue,

dropping DHCP packet!

Jun 23 19:58:45 CTT: dhcp_snooping_draco2_new_dhcp_pak: failed to setup enqueue,

dropping DHCP packet!

Jun 23 19:58:46 CTT: dhcp_snooping_draco2_new_dhcp_pak: failed to setup enqueue,

dropping DHCP packet!

Jun 23 19:58:47 CTT: dhcp_snooping_draco2_enable_mode_change: dhcp snooping disa

bled for vlan 16

cat6509-1>show int vlan16

Vlan16 is administratively down, line protocol is down

  Hardware is EtherSVI, address is 0011.5d2a.0800 (bia 0011.5d2a.0800)

  Internet address is 10.0.15.252/24

  MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:00:01, output 3d00h, output hang never

  Last clearing of "show interface" counters 2d05h

  Input queue: 76/75/556366/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 0 bits/sec, 0 packets/sec

  5 minute output rate 0 bits/sec, 0 packets/sec

     39569 packets input, 2611554 bytes, 0 no buffer

     Received 317752 broadcasts, 0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     0 packets output, 0 bytes, 0 underruns

     0 output errors, 0 interface resets

     0 output buffer failures, 0 output buffers swapped out

cat6509-1>

cat6509-1>show ver

Cisco Internetwork Operating System Software

IOS (tm) s72033_rp Software (s72033_rp-PS-M), Version 12.2(17a)SX4, EARLY DEPLOY

MENT RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Thu 22-Apr-04 01:44 by pwade

Image text-base: 0x40008FBC, data-base: 0x41C92000

ROM: System Bootstrap, Version 12.2(17r)S2, RELEASE SOFTWARE (fc1)

BOOTLDR: s72033_rp Software (s72033_rp-PS-M), Version 12.2(17a)SX4, EARLY DEPLOY

MENT RELEASE SOFTWARE (fc1)

cat6509-1 uptime is 3 years, 18 weeks, 6 days, 3 hours, 20 minutes

Time since cat6509-1 switched to active is 3 years, 18 weeks, 6 days, 3 hours, 1

9 minutes

System returned to ROM by unknown reload cause - suspect boot_data[BOOT_COUNT] 0

x0, BOOT_COUNT 0, BOOTDATA 19 (SP by power-on)

System restarted at 18:50:07 CTT Thu Feb 15 2007

System image file is "sup-bootflash:s72033-ps-mz.122-17a.SX4.bin"

cisco WS-C6509 (R7000) processor (revision 3.0) with 458752K/65536K bytes of mem

ory.

Processor board ID SAL0825ALSS

SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache

Last reset from power-on

X.25 software, Version 3.0.0.

Bridging software.

53 Virtual Ethernet/IEEE 802.3  interface(s)

82 Gigabit Ethernet/IEEE 802.3 interface(s)

1917K bytes of non-volatile configuration memory.

8192K bytes of packet buffer memory.

65536K bytes of Flash internal SIMM (Sector size 512K).

Configuration register is 0x2102

cat6509-1>

Thanks in advance

pengyu

Everyone's tags (2)
1 REPLY
New Member

Re: help! DHCP in 6509 can't work well

Is anyone want to know more detail?

who can answer me?

880
Views
0
Helpful
1
Replies