There is a web GUI on these switches, but it isn't always installed or enabled. If you're not getting a response via HTTP or HTTPS, it's a fair bet that it isn't turned on. You can enable access to it by adding "ip http server" to the switch configuration from the CLI, but if the web-based device manager isn't installed, you're only going to get a rudimentary interface to work with.
If you really need web-based access on this switch, upgrade to the latest software that includes the web-based device manager. Select your switch from the following link and proceed from there:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...