08-09-2013 08:44 PM - edited 03-07-2019 02:51 PM
Hi Everyone,
I am tracing route from say sw1 in network.
From Sw1 say i am tracing 192.168.50.10
Sw1 say to reach the destination 192.168.50.10 next hop is 192.168.60.1.
I went to device say sw2 and found the interface with ip 192.168.60.1.
now from sw2 i again did sh route 192.168.50.10 it shows sw2 learn the route statically and next hop is 192.168.70.1.
now i went to sw3 and found that this ip is svi vlan20 192.168.70.1.
Also i found that sw3 has destination ip with svi vlan10 192.168.50.1.
Need to know if my tracing should end on sw3 ?
Regards
MAhesh
Solved! Go to Solution.
08-09-2013 09:09 PM
Hi Mahesh,
The traceroute should end on the device owning 192.168.50.10. So not sw3 but the device directly connected to it.
Regards
08-09-2013 09:09 PM
Hi Mahesh,
The traceroute should end on the device owning 192.168.50.10. So not sw3 but the device directly connected to it.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide