Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Help in tracing a Route

Hi Everyone,

I  am tracing route from say sw1  in network.

From Sw1 say i am tracing 192.168.50.10

Sw1  say to reach the destination 192.168.50.10 next hop is 192.168.60.1.

I went to device  say sw2  and found the interface with ip 192.168.60.1.

now from sw2 i again did  sh route 192.168.50.10  it shows sw2  learn the route  statically and next hop is 192.168.70.1.

now i went to sw3  and found that this ip is svi vlan20 192.168.70.1.

Also i found that sw3 has destination ip with svi vlan10 192.168.50.1.

Need to know if my tracing should end on sw3 ?

Regards

MAhesh

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Help in tracing a Route

Hi Mahesh,

The traceroute should end on the device owning 192.168.50.10. So not sw3 but the device directly connected to it.

Regards

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
1 REPLY
Cisco Employee

Help in tracing a Route

Hi Mahesh,

The traceroute should end on the device owning 192.168.50.10. So not sw3 but the device directly connected to it.

Regards

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
199
Views
0
Helpful
1
Replies
CreatePlease login to create content