Hey guys , I'm having a hard time with my Catalyst 2950 Switch.I deleted my IOS image completely and , now I'm having problem with the reverse process.I have another Catalyst 2950 , same model working fine , how do I copy the IOS image from the good Switch to the other one ?
Thx Leo, I had fixed the problem successfully after using a different terminal emulator program.There was a problem with PuTtY and Teraterm , that's why I couldn't reinstall the IOS image even if I followed the proper steps to do so.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...