I need some help with setting up routes for the internet. Right now we have the router in the remote site and the way it connects, is T1 goes from main office to remote site and then from router to a switch to everyone in the office. Also the internet goes on that route. We have put in a new internet provider for that site due to speed. Now i want all the internet traffice to come through the new cable modem via switch and the remaining traffic still routes from cisco 1841 back to main office for network and email pruposes.
i have a following attachments for review. Any help would be greatly appreciated
From your diagram, suggest you connect the Internet cable/modem to the 1800, use just a single default route to it.
You might also consider, at both sites, originate the default route into your EIGRP domain. Each site should go to nearest Internet connection, but if either sites loses its Internet connection, and it's default is withdrawn, other site could at least still have Internet access via the other.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...