I have recently started with Cisco Networking so my knowledge is still quite basic.
We have a Cisco 4506 with a Supervisor Engine V and I have configured to prioritize Packets with DSCP Value of 46 for our Voip environment(Softphones).
I have mapped all other DSCP Values to different queues and allowed just DSCP = 46 to be mapped to TxQueue 3. Qos is globally enabled on the switch and the Gigabit Interface is set to trust the received DSCP Values. Then I have assigned a high priority to TxQueue 3 and reseved a bandwidth of 10 Mbps.
If i connect my laptop now to said interface and run Wireshark + our Softphone(eyeBeam) I can verify that all packets are sent with a DSCP Vlaue of 46, however my packet counter for TxQueue3 on said interface remains near to 0 and TxQueue 1 is filling up instead.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...