Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Helppppp!!!!!

Hello Guru of Cisco !!!  I have a problem with STP.... I have a switch 3560 and its connected to the core switch by Cisco Aironet 1410 and cisco modem 878. I configured on switches RSTP. But when i open two interfaces in 3560 where connected Aironet and modem there is a loop. I found that Modem 878  which connected to the switch 3560 dot recive bpdu packets from Core. And it made itself as a root. Root must be Core switch. How to configure modem 878 so it will send BPDU packets form core....?

P.S. Thanks !!! My english is not good enough, so excuse me:)... I hope u understand my question

 

Everyone's tags (1)
2 REPLIES

Hello Can you post a little

Hello

 

Can you post a little topology diagram for a clearer understanding-and maybe a output of the curect config

"But when i open two interfaces in 3560 where connected Aironet and modem there is a loop".

 

res

Paul

Please don't forget to rate any posts that have been helpful. Thanks.
New Member

So here is my topology!!!

So here is my topology!!!

52
Views
0
Helpful
2
Replies
CreatePlease to create content