We're looking for documentation describing how to configure high-availability in a data center environment. We have an Ethernet network port on each of two separate data center-managed Cisco 6500 switches, which we'd like to connect to two Cisco ASA 5500 firewalls that we would manage such that connectivity would fail-over from one port to the other or from one firewall to the other in the event of a switch/port/firewall failure. If someone could point us at any documentation that explains how to do this, that would be great.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...