Thanks for your answer but the 3750 is not member of a stack. It is a standalone device.
And the diags I have already done allow me to be quite sure that the high CPU comes from IP packets that are not hardware switched.
By the way, I forgot to say that once I saw a strong CPU increase on this device just after adding a static route. When I removed this static route, the CPU went back to normal. And it increased again anormally when I added this route once more.
This route was a /25 prefix. And when I replaced it by the same route but configured as a /24, the CPU went back to normal again. All of those elements make me think that this is really a matter of programmation of the routes in the hardware of the switch. But I don't understand why since the command issued "show platform tcam utilization" does not highlight any threshold exceeding. I am within the hardware limits...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.