Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

High Discard Rate Error from Cisco LMS for switch 2950

Hi,

As always, the Cisco LMS is keep sending the follwoing high discard error from the Cisco switches WS-C2950T-24:

EVENT ID               = 0004SX3

ALERT ID               = 00019LF

TIME                   = Tue 14-Feb-2012 08:56:35 GMT

STATUS                 = Active

SEVERITY               = Critical

MANAGED OBJECT         = 192.168.9.152

MANAGED OBJECT TYPE     = Switches and Hubs

EVENT DESCRIPTION       = HighDiscardRate::Component=PORT-192.168.9.152/0.26 [Gi0/2] [--- S100547 ---];ComponentClass=Port;ComponentEventCode=1048;Type=ETHERNETCSMACD;OutputPacketDiscardRate=0.0 PPS;MaxSpeed=1000000000;InputPacketRate=1.7897486E7 PPS;MinimumDiscardRate=8333

I saw the post below for Martin but it is not resolved yet, can anyone help ?

https://supportforums.cisco.com/message/657024#657024

Thanks,

Everyone's tags (4)
4 REPLIES
New Member

High Discard Rate Error from Cisco LMS for switch 2950

Hi,

2960 IOS Version: 12.1(22)EA11

I had the same issue if you look at CiscoView and monitor the interface discards, the graph is erratic - I fixed this issue with an IOS upgrade on the switch.

New Member

High Discard Rate Error from Cisco LMS for switch 2950

Hi,

I have IOS version 12.1(22)EA4, RELEASE SOFTWARE (fc1), to which IOS version did you upgrade ?

Thanks,

High Discard Rate Error from Cisco LMS for switch 2950

Hi,

This fault is reported if:

"The input packet queued rate is greater than the minimum packet rate, and the input packet discard percentage is greater than the Discard Threshold. The input packet queued rate is the rate of packets received without error. The input packet discard percentage is calculated by dividing the rate of input packets discarded by the rate of packets received.

"The output packet queued rate is greater than the minimum packet rate, and the output packet discard percentage is greater than the Discard Threshold. The output packet queued rate is the rate of packets sent without error. The output packet discard percentage is calculated by dividing the rate of output packets discarded by the rate of packets sent.


Please rate all the helpfull posts.
Regards,
Naidu.

New Member

High Discard Rate Error from Cisco LMS for switch 2950

Can anyone help me with my request

1585
Views
0
Helpful
4
Replies