Cisco Support Community
Community Member

High 'throttles' and 'ignored' on FastEthernet port

Below is a snapshot of our FA0/0, would the 'throttles' disable the port? How do I see if I have a buffer problem?

FastEthernet0/0 is up, line protocol is up

Hardware is i82543 (Livengood), address is 0002.7df8.0c08 (bia 0002.7df8.0c08)

Internet address is

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s, 100BaseTX/FX

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:00, output 00:00:00, output hang never

Last clearing of "show interface" counters 3d20h

Input queue: 0/4096/28273 (size/max/drops); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

30 second input rate 90000 bits/sec, 183 packets/sec

30 second output rate 78000 bits/sec, 117 packets/sec

74781102 packets input, 280028316 bytes

Received 252587 broadcasts, 0 runts, 0 giants, 372 throttles

514119 input errors, 0 CRC, 0 frame, 0 overrun, 514119 ignored

0 watchdog

0 input packets with dribble condition detected

45770395 packets output, 3741394477 bytes, 0 underruns

36 output errors, 0 collisions, 36 interface resets

0 babbles, 0 late collision, 0 deferred

36 lost carrier, 0 no carrier

0 output buffer failures, 0 output buffers swapped out


Re: High 'throttles' and 'ignored' on FastEthernet port

To get more details about the counters 'ignored' and 'throttles' and the common causes, refer to Troubleshooting Switch Port and Interface Problems

To determine if you have any issues with buffer, refer to Troubleshooting Buffer Leaks

CreatePlease to create content