Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

home adsl setup

was wondering if its poss to configure a 2610 router as my permiter router (and my default GW) with the BT adsl wireless router as the edge router.

so the set up i would like to have is:

Internet

|

ADSL router

e0 - 192.168.20.1/24 -> port f0/1 on switch - VLAN1

|

|

f0 192.168.20.2/24 -> port f0/2 on switch VLAN1

Cisco 2610 router (only 1 physical interface)

f0.1 172.16.1.1/24 VLAN 2

|

|

HOST -> port f0/3 on switch VLAN 2 - 172.16.1.2/24 GW 172.16.1.1

there will be a default route on router 0.0.0.0. 0.0.0.0 192.168.20.1

Is this setup poss?? also, am i right in saying that there should be NAT statements on the 2610 router?

Regards

102
Views
0
Helpful
0
Replies