if you want to receive administratively prohibited unreachable messages then you have to enable the sending of such message on the L3 interface if it was disabled by issuing the ip unreachable interface command.
You can verify the setting with sh ip interface command.
You cant ping the host because you have permited only 3389 port only. Why you are getting ICMP time out OR Request Timed Out is....
When you are trying to ping the host, in the other case the packet reaches the destination IP and while on the return trip to the source it gets dropped due to you denied it in the access-list
When the packet does not reach the destination IP due to the unavailability of the IP in the routers routing table or the IP is down on the network or the server is down or other reasons you will get a ” Destination host Unreachable” message
Hope the above clear and understand you. Please rate all the helpfull posts. Regards, Naidu.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...