Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Hosts not connecting to WS-4418-GB card after setting module to LACP

On User's Cat/OS, he has enabled LACP on modules 1 & 6 for a 4 Gb LACP aggregation. This works fine, but user now wants to connect individual hosts to remaining ports on module 6. I had the user issue "set port lacp-channel 6/3-18 mode off" on the non-aggregated ports. The hosts will not connect on ports 6/3-14, but do connect properly on 6/15-18. Speed/duplex/vlan assignment are all the same on the various ports. I'm having him also check media-type on these ports because there is a choice between copper and fiber.

1 REPLY
Bronze

Re: Hosts not connecting to WS-4418-GB card after setting module

I think 1000BaseX (GBIC) Card will use for WS-X4418 model. I think to configure EtherChannel on Ethernet module ports, use the set port channel command set.

http://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a0080094470.shtml#conf

154
Views
0
Helpful
1
Replies